Customer Reviews
Cart: 0 Item(s): $0.00

Hix Cap Press

The B-250D is very portable making it easy to take to shows and operate. The transfer hold down blanket means transfers don't shift anymore! This heat press comes with 3 interchangeable platens - Golf size (3″ x 5-1/2″), Youth size (2-3/4″ x 5-1/4″) and ball size (3-3/4″ x 5-7/8″). Shipped from manufacturer. Allow an additional 3-5 days for shipping.

More product details…
Press Size:
Type of Press:
Cap Press
110v or 220v
Item #:
Review to get 200 PW Reward Points (Up to 600 Points)

Availability: In stock

* Required Fields

Your Price: $729.00

or Clear Form
  • Details
  • Reviews
  • Product Details

    With a standard heat platen of 3-7/8"x 5-7/8", place transfers easily onto hats! The B-250D cap press is a manual machine with a 3-7/8" x 7-1/4" heat platen. It features a digital timer (optional analog) that is adjustable up to 999 seconds and shows countdown on readout; then beeps after elapsed time and resets when the easy to open and close handle (with full range pressure adjustment) is raised. The calibrated digital temperature control is adjustable up to 450°F (232°C) and displays the current temperature. The innovative bottom cap hold-down stretches the cap out holding it snug to the lower (rubber covered) platen. A PTFE blanket is suspended between the upper and lower platen to hold the transfer (or lettering) in place before the heating element is locked down. This heat press comes with 3 interchangeable platens - Golf size (3″ x 5-1/2″), Youth size (2-3/4″ x 5-1/4″) and ball size (3-3/4″ x 5-7/8″).

  • Customer Reviews

    Rate or review to get 200 PW Reward Points(What is this?)
    pretty bummed Review by Valentin T
    I wanted to buy American, and I have a very old second hand Hix press that still works but I've had a lot of problems with this press. The heat element and the platen don't line up flush against each other so you're forced to add more pressure to the clamp down which is a lot of wear on the press, my first one snapped at the weld, sent it back, they sent a replacement, that one would not heat up , called HIX tech support , they had me go and buy a volt meter and poke around inside the machine while on the phone with them to isolate and diagnose the problem. Sent back again, one my third one now , same issue with uneven pressure on clampdown causing inconsistency with transfer adhesion. I want to love this machine but its been very problematic. However I love the built in teflon sheet and customer service was very good. (Posted on 5/1/20)