You can easily print a 20 oz Skinny Tumbler in your 3D vacuum press with this silicone wrap. Easy to close clasp on the top and bottom of the wrap.
Use with our 3D sublimation vacuum heat press only!
In Stock - Available for immediate delivery
Skinny 20oz Tumbler Wrap For Sublimation
|Sub Blank Size||20 oz Skinny Tumbler|
Texprint Sublimation Paper on 20oz Skinny Tumbler with a 3D Vacuum Heat Press
- Turn the 3D Vacuum Heat press on.
- Set the heating button so both the top and bottom heating lights are on. (2 red lights will be showing)
- Set the Temperature to 338 degrees F (170 degrees C) and time to 360 seconds (6 minutes).
- Print a mirror image onto Texprint Paper.
- Trim the edges of the image and wrap around the tumbler.
- Attach the image to tumbler using transfer release tape.
- Wrap tumbler with the skinny tumbler wrap.
- Place the tumbler on its side within the press.
- Press vacuum button
- Press the time button
- Remove immediately once finished and peel hot. Use caution as the tumbler will be very hot.
Write Your Own Review