Supacolor Promotional on and Umbrella Application Instructions

1. Set Temperature and Time

• 290F (140C)
• 6-8 seconds

2. Load a Test Umbrella

Open umbrella and lay on top of the platen, use smallest platen you have. You cannot press over the ribs of the umbrella.

3. Set Pressure

• Manual Press: Tighten dial until the press won’t close. Loosen dial progressively until the press closes, use Med to low less pressure for umbrellas.
• Hotronix and Geo Knight: 6-7
• Pneumatic Press: 30-35 PSI

4. Pre-Press: 4-6 Seconds

Pre press umbrella for 4-6 seconds to take out initial shrinkage.

5. Place Supacolor Transfer

Position your Supacolor transfer on the umbrella. Lay the teflon sheet or parchment paper over the Supacolor.

6. Press 6-8 Seconds

7. Peel Immediately

Hot peel immediately from a corner in one smooth motion. Peel with confidence and without hesitation. Hold down umbrella with your free hand for better control.

8. Post-Press: 2 Seconds

Use a Non-stick sheet or parchment to seal the edges of the Supacolor.