CLEARANCE SALE   Huge savings up to 70%    SHOP NOW >
As low as $0.99

This Ring Holder is the accessory that every cell phone case needs. The buckle design is easy to hold to capture your selfie at the perfect angle. A white circle insert can be personalized and attached with double sided adhesive. Imprint area is 7/8" (cell phone and cell phone case not included).

Ring Holder for Cell Phone Case

More Information
SKU SB-S-006A-014A
Finish Glossy
Substrate Aluminum
Protective Film No
Mirror Image Yes

Texprint Sublimation Paper on Small Metal Products

Application Instructions

  1. Set temperature to 400 degrees Fahrenheit.
  2. Set timer to 30-45 seconds.
  3. Set Pressure at medium.
  4. Remove protective film from the product (if applicable).
  5. Print a mirror image onto Texprint Paper. Image should be larger than the substrate.
  6. Place the substrate face down on the transfer paper and tape the paper to the substrate using transfer release tape.
  7. Put a blank sheet of paper on heat press platen to keep it clean.
  8. Place substrate face up on the heat press with the transfer paper on top.
  9. Cover with a non stick sheet.
  10. Press at 400 degrees F for 30-45 seconds with medium pressure.
  11. Remove immediately from press once finished and peel hot.

Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account