Customer Reviews
Cart: 0 Item(s): $0.00

Ring Holder for Cell Phone Case

This Ring Holder is the accessory that every cell phone case needs. The buckle design is easy to hold to capture your selfie at the perfect angle. A white circle insert can be personalized and attached with double sided adhesive. Imprint area is 7/8" (cell phone and cell phone case not included).

Brand:
Pro World
Finish:
Gloss
Substrate:
Aluminum
Item #:
SB-S-006A-014A

Be the first to review this product

Review to get 200 PW Reward Points (Up to 600 Points)

Availability: In stock

* Required Fields

1-49 50+
$2.99 $2.69
or Clear Form
  • Details
  • Instructions
  • Reviews
  • Product Details

  • Application Instructions

    1. Set temperature to 400 degrees Fahrenheit.
    2. Set timer to 30-45 seconds minutes.
    3. Set Pressure at medium.
    4. Remove protective film from product.
    5. Print a mirror image onto Texprint Paper. Image should be larger than the substrate.
    6. Place the substrate face down on the transfer paper and tape the paper to the substrate using transfer release tape.
    7. Put a blank sheet of paper on heat press platen to keep it clean.
    8. Place substrate face down on the heat press (metal surface up).
    9. Cover with a non stick sheet.
    10. Press at 400 degrees F for 30-45 seconds with medium pressure.
    11. Remove immediately from press once finished and peel hot.
  • Customer Reviews

    Rate or review to get 200 PW Reward Points(What is this?)