NEW! Supacolor Custom Transfers. Upload art or design online.   LEARN MORE >

Texprint Sublimation Paper on a Tumbler Mug with 3D Vacuum Press

Application Instructions

  1. Turn the 3D Vacuum Heat press on.
  2. Set the Temperature to 392 degrees F (200 degrees C) and time to 5-6 minutes.
  3. Set the heating button so both the top and bottom heating lights are on.
  4. Print a mirror image onto Texprint Paper. Image should be larger than the substrate.
  5. Wrap the printed image around the Tumbler and secure with heat transfer tape.
  6. Place the tumbler in a tumbler wrap (SB-S-071) and secure the top.
  7. Open the 3D vacuum press and connect the clear tube to the lid of the tumbler wrap.
  8. Press vacuum button.
  9. Press the time button.
  10. At the halfway point, open the top lid and flip the tumbler so it is resting on the other side. Close lid to complete the sublimation process.
  11. Remove immediately once finished and peel hot. Use caution as tumbler will be very hot.