CLEARANCE SALE   Huge savings up to 70%    SHOP NOW >

Texprint Sublimation Paper on Hardboard Products w/ 3D Vacuum Heat Press

Application Instructions

  1. Turn the 3D Vacuum Heat press on.
  2. Make sure the small top tray is in place with the tubing connected to the tray.
  3. Set the heating button so both the top and bottom heating lights are on.
  4. Set the Temperature to 200 degrees C and time to 180-240 seconds.
  5. Print a mirror image onto Texprint Paper.
  6. Remove the protective film from the hardboard product.
  7. Place the substrate face down on the transfer paper and tape the paper to the substrate using transfer release tape.
  8. Place substrate face up within the small tray of the 3D vacuum heat press.
  9. Close and lock the small tray
  10. Press the vacuum button
  11. Close the top lid and press the time button.
  12. Remove immediately with gloves and peel hot.
  13. Use caution as the printed product will be hot.