CLEARANCE SALE   Huge savings up to 70%    SHOP NOW >

Texprint Sublimation Paper on a Water Bottle with 3D Vacuum Press

Application Instructions

  1. Turn the 3D Vacuum Heat press on.
  2. Set the Temperature to 392 degrees F (200 degrees C) and time to 3:30 minutes.
  3. Set the heating button so both the top and bottom heating lights are on.
  4. Print a mirror image onto Texprint Paper. Image should be larger than the substrate.
  5. Wrap the printed image around the water bottle and secure with heat transfer tape.
  6. Place the water bottle in a tumbler wrap (SB-S-071) and secure the top.
  7. Open the 3D vacuum press and connect the clear tube to the lid of the tumbler wrap.
  8. Press vacuum button
  9. Press the time button
  10. Remove immediately once finished and peel hot. Use caution as water bottle will be very hot.