STAINLESS STEEL COLA BOTTLE - GLITTER SEAFOAM GREEN

Texprint Sublimation Paper on a Glitter Water Bottle with Mug Press

Application Instructions

1. Set temperature to 380-400 degrees Fahrenheit.
2. Set timer to 180 seconds.
3. Set Pressure at medium.
4. Print a mirror image onto Texprint Paper. Image should be larger than the substrate.
5. Wrap the printed image around the water bottle and secure with heat transfer tape.
6. If your water bottle is loose within the Mug Press, place a silicone cover around the water bottle.
7. Press at 380-400 degrees F for 180 seconds with medium pressure.
8. Remove immediately from press once finished and peel hot. Use caution as water bottle will be very hot.

Stainless Steel In A Sublimation Oven

Application Instructions

1. Set upper and lower oven temperature to 365° Fahrenheit
2. Set oven timer to 6 minutes.
3. Print a mirror image onto Texprint Paper.
4. Wrap the printed image around product and secure it with heat transfer tape.
5. Slip your drinkware into the recommended shrink film sleeve.
6. Apply heat to the shrink film using a heat gun until the film is tight on the item.
7. Once the sublimation oven beeps confirming it has reached the appropriate temperature, place your item in
8. the oven and close the door.
9. Heat your product for 6 minutes at 365° F
10. Remove immediately from oven once finished and peel hot. Use caution as the item will be very hot.

*A heat gun is required for irregular shaped drinkware. If printing on products with straight sides like a skinny tumbler, a heat gun is not needed, as the film will shrink with the heat from the oven.