As Low As
$6.99
1-11
$7.99
12-23
$7.69
24+
$6.99
Stock Availability:
Backordered
Features
SKU | SB-S-063 |
---|---|
Finish | N/A |
Substrate | Slate |
Sub Blank Size | 11" x 5.5" |
Textprint Sublimation Paper on a Rock Slate with a 3D Vacuum Press
Application Instructions
- Set temperature to 400 degrees Fahrenheit (200 C)
- Set timer to 5:30-7 minutes depending on the rock slate size. The larger the rock slate, the longer the time should be.
- Keep top tray in the 3D Vacuum press, and connect tubing to the bottom of the tray.
- Press Heating Button twice so both lights are on.
- Print a mirror image onto Texprint Paper. Image should be larger than the substrate.
- Place the substrate face down on the transfer paper and tape the paper to the substrate using transfer release tape.
- Place substrate face up in the top tray of the 3D Vacuum Press.
- Press vacuum button. Then timing button to begin the timer.
- Press at 400 degrees F for 5:30-7 minutes.
- Remove immediately from press once finished and peel hot. Use caution as rock slate will be very hot.
Textprint Sublimation Paper on a Rock Slate with a Heat Press
Application Instructions
- Set temperature to 415 degrees Fahrenheit.
- Set timer to 300-400 seconds depending on the rock slate size. The larger the rock slate, the longer the time should be.
- Set Pressure at medium-heavy. Use caution as the rock slate can crack with too much pressure.
- Print a mirror image onto Texprint Paper. Image should be larger than the substrate.
- Place the substrate face down on the transfer paper and tape the paper to the substrate using transfer release tape.
- Place substrate face up on the heat press.
- Cover with a piece of fabric (cut tshirt) to protect the coating of the rock slate.
- Then cover with a silicon pad.
- Press at 415 degrees F for 300-400 seconds with medium-heavy pressure.
- Remove immediately from press once finished and peel hot. Use caution as rock slate will be very hot.
Write Your Own Review