20 OZ GLOW IN THE DARK SKINNY TUMBLER W STRAW

Texprint Sublimation Paper On A Skinny Tumbler with Mug Press

Application Instructions

1. Set temperature to 350 degrees Fahrenheit.
2. Set timer to 80-100 seconds.
3. Set Pressure at medium.
4. Print a mirror image onto Texprint Paper.
5. Wrap the printed image around product and secure it with heat transfer tape.
6. Press at 350 degrees F for 80-100 seconds with medium pressure.
7. If printing a design that wraps around the tumbler, rotate the tumbler and press for another 80-100 seconds.
8. Remove immediately from press once finished and peel hot. Use caution as the item will be very hot.

Texprint Sublimation Paper on 20oz Skinny Tumbler with a 3D Vacuum Heat Press

Application Instructions

1. Turn the 3D Vacuum Heat press on.
2. Set the heating button so both the top and bottom heating lights are on. (2 red lights will be showing)
3. Set the Temperature to 338 degrees F (170 degrees C) and time to 360 seconds (6 minutes).
4. Print a mirror image onto Texprint Paper.
5. Trim the edges of the image and wrap around the tumbler.
6. Attach the image to tumbler using transfer release tape.
7. Wrap tumbler with the skinny tumbler wrap.
8. Place the tumbler on its side within the press.
9. Press vacuum button
10. Press the time button
11. Remove immediately once finished and peel hot. Use caution as the tumbler will be very hot.

20oz Tumbler In A Sublimation Oven

Application Instructions

1. Set upper and lower oven temperature to 365° Fahrenheit
2. Set oven timer to 6 minutes.
3. Print a mirror image onto Texprint Paper.
4. Wrap the printed image around product and secure it with heat transfer tape.
5. Slip your drinkware into the recommended shrink film sleeve.
6. Apply heat to the shrink film using a heat gun until the film is tight on the item.
7. Once the sublimation oven beeps confirming it has reached the appropriate temperature, place your item in
8. the oven and close the door.
9. Heat your product for 6 minutes at 365° F
10. Remove immediately from oven once finished and peel hot. Use caution as the item will be very hot.

*A heat gun is required for irregular shaped drinkware. If printing on products with straight sides like a skinny tumbler, a heat gun is not needed, as the film will shrink with the heat from the oven.

Texprint Sublimation Paper on Stainless Steel with Convection Oven

Application Instructions

1. Set temperature to 400 degrees Fahrenheit.
2. Set timer to 5-7 minutes (300-420 seconds).
3. Print a mirror image onto Texprint Paper. 
4. Wrap the printed image around product and secure with heat transfer tape.
5. Place the tumbler in a medium vacuum seal bag and tuck the opening of the bag inside the tumbler.
6. Place tumbler in a convection oven at 400 F for 5-7 minutes.
7. When complete remove the tumbler from the oven when hot and remove the bag and texprint paper. Use caution as the item with be very hot.